This study used capillary electrophoresis (CE) to investigate the simultaneous separation and on-line concentration of five pesticides: amitrole (AMT), carbendazim (MBC), 2-aminobenzimidazole (ABI), thiabendazole (TBZ) and 1,2-diaminobenzene (DAB). A volatile migration buffer was used for the investigation because of the applicability to mass spectrometric (MS) detection. They were separated completely at pH 4.0 as a result of changing pH using formic acid–ammonium formate buffer. Values of the dissociation constant for MBC and DAB estimated from the changes in the mobility with pH showed good agreement with values in the literature. Dissociation constants for AMT and TBZ were estimated. Limits of detection (LODs) for the analytes were on the ppm level with UV detection under the optimized separation condition. On-line concentration by simple stacking mode was not effective except to 2-aminobenzimidazole because of the peak tailing. The addition of formic acid to sample matrix improved the peak shapes. That improvement may be attributed to transient isotachophoretic effect. The concentration factors obtained from the comparison of the LODs were in the range of 7.6–27-fold. This concentration method was applied preliminarily to CE with MS detection.

Separation and on-line concentration of bisphenol A and three alkylphenols were investigated by micellar electrokinetic chromatography with the anionic surfactant, sodium dodecyl sulfate. The separation conditions were optimized by the simultaneous addition of the organic solvent and cyclodextrin to the running solution. The separation of hydrophobic analytes and 4-nonylphenol isomers was improved by the addition of 10% methanol and 5 mM β-cyclodextrin to the running solution. When the sweeping with the running solution was used as the on-line concentration procedure, 69-, 48-, 55- and 41-fold increases in detection sensitivity were obtained for bisphenol A, 4-tert.-butylphenol and 4-(1,1,3,3-tetramethylbutyl)phenol, and the second peak of 4-nonylphenol isomers, respectively. The detection limits were 0.0071, 0.0065, 0.021 and 0.055 mg/l, respectively. These results were better than those with the cationic surfactant, tetradecyltrimethylammonium bromide.

The separation and on-line concentration of bisphenol A and three alkylphenols were investigated by micellar electrokinetic chromatography with cationic surfactant. Tetradecyltrimethylammonium bromide was used as surfactant and the separation conditions were optimized by the addition of the organic solvents and cyclodextrins to the running solution. The separation of hydrophobic analytes and 4-nonylphenol isomers was improved by the addition of 20% acetonitrile and 20 mM β-cyclodextrin to the running solution. When the sweeping with the running solution used as the on-line concentration procedure, 56-, 67- and 29-fold increase in detection sensitivity of bisphenol A, 4-tert.-butylphenol and 4-(1,1,3,3-tetramethylbutyl)phenol, respectively. The detection limits were 0.030, 0.098 and 0.159 mg/l, respectively.

In order to develop an advanced analytical method using capillary electrophoresis (CE) for non-volatile environmental pollutants such as endocrine disruptors, combination with mass spectrometry (MS) is necessary for their identification. We chose dichlorophenols (DCPs) as test samples because one of their isomers, 2,4-DCP, is suspected to have endocrine disrupting effects. A preliminary study on their separation by CE–MS was performed using a laboratory-made electrospray ionization (ESI) interface. For the effective ionization of 2,4-DCP at the ESI interface, applied voltage, assisted nitrogen-gas flow-rate, salts and their concentration, and organic solvents in the sample matrix were optimized according to the signal intensity. The intensity of other DCPs under the same conditions, however, was quite different. We tried to modify the atmospheric chemical pressure ionization (APCI) interface in order to reduce the flow-rate. The intensity of directly injected DCPs was not so different from one another using the modified prototype APCI interface.